I picked my print, then I put it in the slot and set it where I wanted it, I think turned on the light and exposed my photo and paper I then did the developer I left it in for to long ( I took it out to late it was already black when I pulled it out) for one of them and it didn't turn turn out, the other one turned out a little bit but not the best. The stop bath just stopped the chemicals from the print. ( 10 seconds in) The fixer just finalized my print. ( 2 minutes in) Overall it was a good experience to have sense I've never done it before, if I did it again I'd try to do it right to actually get a good print.